laguna
technical product info
9. seal ensure tile and grout is completely dry prior to sealing. use prosoco polishguard. follow sealer manufacturer’s recommendations. apply several thin coats of sealer. apply using microfiber applicator dampened with sealer. work in small and manageable sections to allow sealer to dry between coats. sealer should be applied to maintain a natural finish (non-glossy). do not over apply sealer and wipe off any excess. allow proper dry time and cure time (7 days) prior to use. re-apply floor protection during construction. 10. care + maintenance ensure your floor has been adequately wet-scrubbed and sealed prior to use. should water or liquid not bead up on the surface, additional sealer coats can be applied to ensure tiles repel spills. caring for your concrete tile is relatively simple with routine maintenance. concrete tiles are made of naturally occurring raw materials and much like natural stone patina with age. for the life span of the installation periodic deep clean and rejuvenation can occur. 11. routine care clean floor daily. use warm clean water and ph neutral (non-acidic) detergent. residential: mop regularly. commercial: use floor machine/auto scrub regularly. frequency of maintenance depends on traffic and use. wipe up spills immediately. give immediate attention to acidic liquids like lemon juice. follow sealer manufacturer’s recommendations.
12. future rejuvenation periodically a deeper clean can rejuvenate floors appearance and add protection. ensure tile is cleaned and free of all dust and debris. wet-scrub with floor-machine using htc twister white pad. use ample clean warm water. work in small and manageable sections proper wet-scrubbing will create a slurry. be diligent in removing all slurry water. use a shop-vac. if needed. follow with a clean mop. for smaller areas and vertical surfaces, an orbital hand-sander with a small cut-out of htc twister white pad can be used. the wet-scrub process is transformative in improving the overall floor finish as well as preparation for resealing. reseal with prosoco polishguard. follow sealer manufacturer’s recommendations. apply several thin coats of sealer. apply using microfiber applicator dampened with sealer. work in small and manageable sections to allow sealer to dry between coats. sealer should be applied to maintain a natural finish (non-glossy). do not over apply sealer and wipe off any excess. if you have any questions please contact our technical team: tech@concrete-collaborative.com
-
-
-
-
-
- - - -
- - - - - -
-
-
-
-
- -
-
- -
-
-
-
-
-
- -
-
- - - -
-
- -
-
855.268.0800 | concrete-collaborative.com | sales@concrete-collaborative.com
Powered by FlippingBook